Safe operation of turbo compressors thanks to surge line detection

29. June 2015

Celeroton converters allow for the monitoring of the operating status of a turbo compressor. Hence, the pumping of the compressor and potentially resulting system damage can be avoided.

If the mass flow (or volume flow) of a turbo compressor drops below its permitted minimum value, the pressure ratio cannot be maintained anymore, which results in a cyclical increase and decrease of the mass flow and the pressure ratio. This unfavourable operating status is called pumping. Pressure surges, which occur during pumping, can damage the compressor and the whole system in the long run. Therefore, this operating status should be implicitly avoided.

The minimal mass flow, which is necessary for a secure operation, is dependent on the pressure ratio and is depicted in the compressor performance map as the surge line. The area on the left hand side of the surge line cannot be covered by the compressor without special measures (grey marked area in subsequent chart).

Surge line
CT-17-700 compressor performance map with surge line and prohibited operating range (grey).

With the use of turbo compressors and converters from Celeroton, you have the possibility to detect the shortfall of the surge line and to avoid any corresponding system damage. If the turbo compressor is run close to the surge line, the converter will generate an appropriate warning. The user can display this warning via the interface of the converter (CAN, RS232/485 or digital/analogue outputs) and can subsequently perform a suitable countermeasure. Nevertheless, if there is pumping during operation of the turbo compressor, the converter will immediately recognise it and display a corresponding error message. In case of failure, the converter will automatically initiate a countermeasure, which returns the compressor in a safe and stable operating status. This countermeasure can be configured by the user. Options are an automatic reduction of the speed or a command to switch-on a side air-valve via the interface of the converter.

< back


Vibration testing of the CT-2X air-bearing turbo compressor for mobile fuel cell applications

Turbo compressors have to cope with the vibration and lifetime requirements when used in mobile fuel cell applications, ...

> more

Gas bearing design for non-air applications

The design of gas bearings for noble or inert gases is an interesting engineer’s challenge, as the design has ...

> more


Combining electronics and a turbo compressor in one device - the new CTi-17-700/1000.GB

Electrification in various industries, especially in mobile applications and vehicles, is more and more driven by ...

> more

Advantages of Celeroton oil-free helium compressors

With its 100% oil-free and gas-tight design, the Celeroton CT-NG-2000 compressor for Helium is the ideal solution for ...

> more